pressed in axle removal

[Steve Chervinsky <63hemipolara@xxxxxxxxx>]

OK, I have the tool to remove the rear wheel flange on the 8 3/4, how
does one remove the axles from the housing, I want to take the pig
out.

Slide hammer? Or does one get a piece of steel with a hole large
enough to put the nut over the end of the axle and then have at it
with a BFH?

Any and all help is MUCH appreciated!!!

-- 
Steve
'63 Hemi Polara

-- 
--
Please address private mail -- mail of interest to only one person -- directly to that person. That is, send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.