Fender Mirror Vacuum Hookup?
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Fender Mirror Vacuum Hookup?



So I discovered my fender mirror is adjusted by a toggle switch with
one main feed line and four vacuum lines running to the fender
mirror.  The lines go to two vacuum diaphrams on the back of the
mirror  that each have two ports.

Two of the lines are colored, one red, one green the others aren't.

Any idea how to hook this up?


I only have one vacuum line coming from the manifold.  It goes to the
heater controls.  I don't even see were the feed line for the mirror
would have been tee'd into the main line, unless it ran over from the
heater controls.  Or, someone did away with the tee years ago.

So, of course, where does the feed come from too?

My mirror is copper plated, pretty cool, anyone else have a copper
plated fendor mirror?

Thanks,

-- 
--
Please address private mail -- mail of interest to only one person -- directly to that person. That is, send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.


Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.