|
In a message dated 10/21/2011 6:21:02 P.M. Central Daylight Time,
hoodoovoodooray@xxxxxxxxx writes:
I'm curious if that bow is going to pull in as I tighten it not sure what flange you have on the headers, I have seen everything from
1/4 to 3/8 inch, chances are that the flange will straighten as you tighten it
down, I have often seen the flanges cut between the ports on the outward
cylinders as well which is a possibility if you do not feel it is pulling down
straight, then again you can contact the mfg. and ask them their opinion and as
to wether they are going to warranty their sealing
-- -- Please address private mail -- mail of interest to only one person -- directly to that person. That is, send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! 1962 to 1965 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. -- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. http://groups.google.com/group/1962to1965mopars?hl=en. |
Back to the Home of the Forward Look Network