|
I believe you'll run into intake bolt/port alignment issues long
before .060.
----- Original Message -----
Sent: Monday, July 11, 2011 5:57 AM
Subject: Re: Milling heads
Mo,,,,,,, if memory serves,,,, this is the correct formula, am sure
that the machine shop that does the milling will know for sure, and as I
recall you can go up to about .060 before causing push rod
problems
mill the intake surface of the head 0.0095 inches for every 0.010 you
take from the deck/head surface.
In a message dated 7/11/2011 12:10:07 A.M. Central Daylight Time,
micher@xxxxxxxxxxxxxxx writes:
i HEAR
THAT WHEN MILLING HEADS, YOU CAM ALSO MILL THE INTAKE MANIFOLD
SIDE OF
THE HEAD TO CORRECT
--
--
Please address private mail -- mail of interest to only
one person -- directly to that person. That is, send parts/car transactions
and negotiations as well as other personal messages only to the intended
recipient, not to the Clubhouse public address. This practice will protect
your privacy, reduce the total volume of mail and fine tune the content signal
to Mopar topic. Thanks!
1962 to 1965 Mopar Clubhouse Discussion
Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html
and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups
"The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.
--
--
Please address private mail -- mail of interest to only one person -- directly to that person. That is, send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks!
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.
|
Back to the Home of the Forward Look Network