I spoke with Craig Studnick from Mobile Parts who is an expert on old brakes. I'd ordered a set of 10 inch drums from Napa but Craig says they're made from bad Chinese metal and warp right away. Can anyone confirm or deny this? I've already paid for them and would like to use them, but not if they're complete garbage. As always, thanks. - Jim Jim Altemose, Long Island, NY '63 Polara 500 (Max Wedge) '63 Polara 500 (383) '65 Belvedere I (Street Wedge) '71 Bronco On Mon, Apr 25, 2011 at 11:31 AM, Jim Altemose <jaltemoose@xxxxxxxxx> wrote: > > I'm a dumb-ass. I need new front 10 inch drums on my 63 Polara 500 > (383). I made the rookie mistake of pounding the studs with a BFH to > get the hubs off the drums, figuring I could just replace the studs on > the hub. So after getting nowhere fast by trying to pound out the > studs, I reviewed some of the postings here and realize now that > they're 'swedged' in. > > So, after ruining everything I need new hubs and studs. Anyone know a > good source? > > Thanks. > > - Jim > Jim Altemose, Long Island, NY > '63 Polara 500 (Max Wedge) > '63 Polara 500 (383) > '65 Belvedere I (Street Wedge) > '71 Bronco > > > ---- > Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! > > 1962 to 1965 Mopar Clubhouse Discussion Guidelines: > http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.