TRIM INSTALL
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

TRIM INSTALL



It's time to put the trim molding back on the car. 

What is the best practice? I am looking at the the wide and narrow 
molding pieces to put back on. 
Is it easiest and best to:
A: put the trim clips on first so they are bottomed out against the body 
then put the molding on. 
Or
B: put the trim clips in the molding, position them in the molding and 
then push the clips into the body. 
Either way I know I have some areas to more positively position the trim 
with the spring type clips first.

Should i protect the body with a sheet of paper behind then remove the 
paper or am i being too careful? 

One other question. Is the narrow trim also made from Stainless? Magnet 
wont work since the wide molding is 300 series stainless (non-magnetic). 
if the narrow trim is stainless I need to do some more polishing and 
buffing.

Any help and advice would be greatly appreciated.
Wayne Huseby
64 polara 500


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. 












Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.