Re: Loooong rams in a B?

[Roger Pettigrew <dodger7998@xxxxxxx>]

Sorry again,,,,,, you were correct due to the fact that the manifolds come  
off of the opposing head,,,,,,
 
 
In a message dated 3/15/2011 1:20:31 P.M. Central Daylight Time,  
dodger7998@xxxxxxx writes:



Sorry  but have to disagree,,,, manifolds will be  setting higher and  
wider, not narrower


In a message dated  3/15/2011 10:56:27 A.M. Central Daylight Time,   
zephyr9900@xxxxxxxxxxx writes:

.   But the RB setup has  the
manifolds sitting higher and narrower over all. As  opposed to the  same 
setup
on a B  block


--
[Non-text portions of  this message have been removed]


----
Please address private mail  -- mail of interest to only one person -- 
directly to that person.  I.e.,  send parts/car transactions and negotiations as 
well as other personal  messages only to the intended recipient, not to the 
Clubhouse public address.  This practice will protect your privacy, reduce 
the total volume of mail and  fine tune the content signal to Mopar topic.  
Thanks!

1962 to 1965  Mopar Clubhouse Discussion  Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and  
http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.  




--
[Non-text portions of this message have been removed]


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.