they will be narrower. I thoght about also. The block is taller on an angle thus pulling each side closeras you go dowen on both sides the carbs will spread out --- On Tue, 3/15/11, Roger Pettigrew <dodger7998@xxxxxxx> wrote: > From: Roger Pettigrew <dodger7998@xxxxxxx> > Subject: Re: Loooong rams in a B? > To: 1962to1965mopars@xxxxxxxxxx > Date: Tuesday, March 15, 2011, 6:19 PM > > > Sorry but have to disagree,,,, manifolds will be > setting higher and > wider, not narrower > > > In a message dated 3/15/2011 10:56:27 A.M. Central Daylight > Time, > zephyr9900@xxxxxxxxxxx > writes: > > . But the RB setup has the > manifolds sitting higher and narrower over all. As > opposed to the same > setup > on a B block > > > -- > [Non-text portions of this message have been removed] > > > ---- > Please address private mail -- mail of interest to only one > person -- directly to that person. I.e., send > parts/car transactions and negotiations as well as other > personal messages only to the intended recipient, not to the > Clubhouse public address. This practice will protect your > privacy, reduce the total volume of mail and fine tune the > content signal to Mopar topic. Thanks! > > 1962 to 1965 Mopar Clubhouse Discussion Guidelines: > http://www.1962to1965mopar.ornocar.org/mletiq.html and > http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. > > > >