clutches.

["MO ( Steve Mick)" <micher@xxxxxxxxxxxxxxx>]

Hay all,   I  looked all over for my big block bell housing for 10 1/2 : 
flywheel  Then knocked on the gates of hades for the right fork . Then 
yesterday I got a 10 1/2" flywheel that needs to be surface ground and  then 
paid extra for a uasble pressure plate. - and it needs to have surface rust 
removed from the face.  Machine shop says the pressure plate would need to 
be taken apart to machine the face. Stock clutch kits are hard to find 
around here. They are available all day long in 11"  I just want something 
temporary until I am ready to drag race it.

Question is--- will the 10 1/2" handle 350-400 HP  I am already cash poor 
to change everything to 11" ------Opinions please?....................MO


{Steve Mick}
http://stevemick.shutterfly.com/pictures#Part%202 


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.