Re: More Sub Frame Connector Questions

["Gary H." <spigot2039@xxxxxxxxxxx>]

http://1962to1965mopar.ornocar.org/ml-hamadayframec.html shows these.

Thanks,
Gary H. 

-----Original Message-----  
>
>I may be biased since I make them but I like the factory look so I make them from 2 X 3 tubing the same gauge as the factory rails. I beg to differ but the front & rear rails are only slightly off center from each other, probably 1 inch. I tie them together starting
>at the rear they clamp the front of the rear frame rail & the floor panel together (which is where the spot welds break in the stock configuration) and go forward to the transmission crossmember. I designed them to look like they're extensions of the factor rails. 
>
>Regards, Hammer 


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.