Hi David
There are 4 the same size, and 1 bigger plug, these have a female square
hole for a rachet or some sort of a square bar to fit into.(smaller than
3/8
but bigger than a 1/4 inch drive rachet?
Now I have fitted the 1 bigger plug and 2 smaller plugs into the back of
the
block (where the flywheel goes).
The other 2, I cant find anything with a thread to screw them into.
I must add that the block also has 2 very small different type of plugs
next
to the engine mounts (1 each side), but as I say, they are very small
and
are already in the block, I think they are water valleys?
These 2 plugs are not the problem, and they can be screwed in with a
shifter
or spanner.
So I have 2 screw in plugs that are of the female type to find a home
for....lol
Thank's
Jim
----- Original Message -----
From: "David Bailey" <bb64d440@xxxxxxxxxxx>
To: <1962to1965mopars@xxxxxxxxxx>
Sent: Thursday, June 10, 2010 10:09 PM
Subject: RE: unlocking pistons?
What size are these plugs? Are all 5 the same size? Might they be ¼" NPT
pipe thread? Don't know for sure but might there be ¼" NPT threaded
holes,
one on each side of the block into the water passages? Some folks put
petcocks in there. Like Chebbies? > To: 1962to1965mopars@xxxxxxxxxx
> From: jimfmd@xxxxxxxxxxxxxxxx
> Subject: Re: unlocking pistons?
> Date: Thu, 10 Jun 2010 21:55:14 +1000
>
>
> Yeah, I am new to Mopar power, I have built a few Clevos, but this plug
> situation has me stumped too.
>
> I did not bother checking this before the block and crank were sent out,
>
> as
> I did not think this was going to happen???????
>
> I have a few other ideas, and maybe contact the machinest and see if he
> remembers where they went?
> I have had the block back for about 6 weeks now.
>
> Thanks anyway
> Jim
>
>
>
> ----- Original Message -----
> From: "doug daniel" <dougdaniel50@xxxxxxxxx>
> To: <1962to1965mopars@xxxxxxxxxx>
> Sent: Thursday, June 10, 2010 9:50 PM
> Subject: Re: unlocking pistons?
>
>
> hum ,,,,,i made the mistake of not putting them in a big block rebuild
> ,,,thought maybe the same in your case,,,
>
> --- On Thu, 6/10/10, Jim <jimfmd@xxxxxxxxxxxxxxxx> wrote:
>
> > From: Jim <jimfmd@xxxxxxxxxxxxxxxx>
> > Subject: Re: unlocking pistons?
> > To: 1962to1965mopars@xxxxxxxxxx
> > Date: Thursday, June 10, 2010, 7:47 AM
> >
> > Hi Doug
> >
> > Thank's for the reply, but there is no thread to screw
> > these plugs in behind
> > the timing cover on this block.
> >
> > They have to go somewhere else.
> >
> > Thank's
> > Jim
> >
> >
> >
> >
> > ----- Original Message -----
> > From: "doug daniel" <dougdaniel50@xxxxxxxxx>
> > To: <1962to1965mopars@xxxxxxxxxx>
> > Sent: Thursday, June 10, 2010 9:43 PM
> > Subject: Re: unlocking pistons?
> >
> >
> > 2 behind timing cover
> >
> > --- On Thu, 6/10/10, Jim <jimfmd@xxxxxxxxxxxxxxxx>
> > wrote:
> >
> > > From: Jim <jimfmd@xxxxxxxxxxxxxxxx>
> > > Subject: Re: unlocking pistons?
> > > To: 1962to1965mopars@xxxxxxxxxx
> > > Date: Thursday, June 10, 2010, 12:36 AM
> > >
> > > Talking about working on poly motors?
> > >
> > > Can somebody please tell me how many "screw in plugs"
> > the
> > > 318 poly motor has?
> > >
> > > I sent my block and crank away to get machined a long
> > while
> > > ago, and when I got the block back, there was a small
> > box
> > > with 5 "screw in plugs" in it.
> > > Now I have fitted 3 of them, they were easy to find,
> > they
> > > screwed into the back of the block.
> > >
> > > Now, I have 2 left to find a home for?
> > > Can somebody tell me where they are meant to go??
> > >
> > > This is holding me up to get the rest of the motor
> > > together, as I would like the motor running in the
> > next 2
> > > weeks???????
> > >
> > > Thank's
> > > Jim
> > >
> > >
> > >
> > > ----- Original Message ----- From: "Gary H."
> > > <spigot2039@xxxxxxxxxxx>
> > > To: <1962to1965mopars@xxxxxxxxxx>
> > > Sent: Thursday, June 10, 2010 2:29 PM
> > > Subject: RE: unlocking pistons?
> > >
> > >
> > > >
> > > > Thanks for the tips everyone.
> > > >
> > > > Paul, it is one of the fun and exotic engines
> > known as
> > > "semi-Hemi" Polys.
> > > >
> > > > (Ignore the current dumb Chrysler TV commercial
> > that
> > > makes fun of the semi-Hemi terminology.) :)
> > > >
> > > > Thanks,
> > > > Gary H.
> > > >
> > > > -----Original Message-----
> > > >
> > > > ....Any chance this is motor is something fun
> > and
> > > exotic like a 392 hemi
> > > >> or???
> > > >>
> > > >> Paul L.
> > > >> '63 Sport Fury
> > > >> 440/727
> > > >
> > > >
> > > > ----
> > > > Please address private mail -- mail of interest
> > to
> > > only one person -- directly to that person.
> > > I.e., send parts/car transactions and negotiations as
> > well
> > > as other personal messages only to the intended
> > recipient,
> > > not to the Clubhouse public address. This practice
> > will
> > > protect your privacy, reduce the total volume of mail
> > and
> > > fine tune the content signal to Mopar topic. Thanks!
> > > >
> > > > 1962 to 1965 Mopar Clubhouse Discussion
> > Guidelines:
> > > > http://www.1962to1965mopar.ornocar.org/mletiq.html and
> > > http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
> > > >
> > >
> > >
> > >
> > --------------------------------------------------------------------------------
> >
> > >
> > >
> > >
> > > No virus found in this incoming message.
> > > Checked by AVG - www.avg.com
> > > Version: 9.0.829 / Virus Database: 271.1.1/2928 -
> > Release
> > > Date: 06/10/10 04:35:00
> > >
> > >
> > > ----
> > > Please address private mail -- mail of interest to
> > only one
> > > person -- directly to that person. I.e., send
> > > parts/car transactions and negotiations as well as
> > other
> > > personal messages only to the intended recipient, not
> > to the
> > > Clubhouse public address. This practice will protect
> > your
> > > privacy, reduce the total volume of mail and fine tune
> > the
> > > content signal to Mopar topic. Thanks!
> > >
> > > 1962 to 1965 Mopar Clubhouse Discussion Guidelines:
> > > http://www.1962to1965mopar.ornocar.org/mletiq.html and
> > > http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
> > >
> > >
> > >
> >
> >
> >
> >
> >
> > --------------------------------------------------------------------------------
> >
> >
> >
> >
> > No virus found in this incoming message.
> > Checked by AVG - www.avg.com
> > Version: 9.0.829 / Virus Database: 271.1.1/2928 - Release
> > Date: 06/10/10
> > 04:35:00
> >
> >
> > ----
> > Please address private mail -- mail of interest to only one
> > person -- directly to that person. I.e., send
> > parts/car transactions and negotiations as well as other
> > personal messages only to the intended recipient, not to the
> > Clubhouse public address. This practice will protect your
> > privacy, reduce the total volume of mail and fine tune the
> > content signal to Mopar topic. Thanks!
> >
> > 1962 to 1965 Mopar Clubhouse Discussion Guidelines:
> > http://www.1962to1965mopar.ornocar.org/mletiq.html and
> > http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
> >
> >
> >
> >
>
>
>
>
>
> --------------------------------------------------------------------------------
>
>
>
>
> No virus found in this incoming message.
> Checked by AVG - www.avg.com
> Version: 9.0.829 / Virus Database: 271.1.1/2928 - Release Date: 06/10/10
> 04:35:00
>
>
> ----
> Please address private mail -- mail of interest to only one person --
> directly to that person. I.e., send parts/car transactions and
> negotiations as well as other personal messages only to the intended
> recipient, not to the Clubhouse public address. This practice will
> protect
> your privacy, reduce the total volume of mail and fine tune the content
> signal to Mopar topic. Thanks!
>
> 1962 to 1965 Mopar Clubhouse Discussion Guidelines:
> http://www.1962to1965mopar.ornocar.org/mletiq.html and
> http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
>
>
_________________________________________________________________
Hotmail has tools for the New Busy. Search, chat and e-mail from your
inbox.
http://www.windowslive.com/campaign/thenewbusy?ocid=PID28326::T:WLMTAGL:ON:WL:en-US:WM_HMP:042010_1
--
[Non-text portions of this message have been removed]
----
Please address private mail -- mail of interest to only one person --
directly to that person. I.e., send parts/car transactions and
negotiations
as well as other personal messages only to the intended recipient, not
to
the Clubhouse public address. This practice will protect your privacy,
reduce the total volume of mail and fine tune the content signal to
Mopar
topic. Thanks!
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and
http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--------------------------------------------------------------------------------
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 9.0.829 / Virus Database: 271.1.1/2928 - Release Date: 06/10/10
04:35:00
Back to the Home of the Forward Look Network