${top_text_ad} I'll try to take some dimensions of mine and post them later today. Gary F. On Sun, Mar 7, 2010 at 9:04 PM, Lynette <lsearles@xxxxxxxxx> wrote: > > > Can anyone provide accurate dimensions of the aluminum seat brackets used on the '65 A990 cars? I want to fabricate my own. > Thank you > [Non-text portions of this message have been removed] > > > ---- > Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! > > 1962 to 1965 Mopar Clubhouse Discussion Guidelines: > http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. > > > ${bottom_text_ad} ---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! 1962 to 1965 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. This email was sent to: ${recipient} u/?bUrDWg.${encoded_sub_id}.${EMC}