Re: Block Machining cost

[Steve Chervinsky <63hemipolara@xxxxxxxxx>]

${top_text_ad}
WOW, machine shop here was going to machine my cylinders with a race
cut, file fit my rings and deck the bock for $250. Guess it helps to
have connections. Just had no money to do it:(

On Tue, Feb 16, 2010 at 7:46 PM, Rich Kinsley <rlkinsley@xxxxxxxxx> wrote:
>
>
> It seems like that's the way it works. It always costs me more than
> expected/wanted. BTW am I in your will just in case you get killed by
> your wife :-)
>
> Rich Kinsley '64 Dodge Polara 4dr 318poly w/goodies
> ====================================================================
> William Harrison wrote:
>>
>> Wow!!!!
>> What a shock when I went to pick up my 383 block from the machine shop
>> today.
>> Just wanted it bored .60 @$18 per cylinder,line bored and cam bearings
>> installed.
>> Before you know it, the block needed to be decked .10 and my new billet
>> main caps needed to be shaved and the lifter bores needed to be honed,
>> yada yada yada.
>> I was going to install the pistons on the rods and install new freeze
>> plugs but I didn't tell him I was going to do that so another few
>> dollars.
>> The little things kept creeping in and before you know it; I just paid
>> $1260.00 for that sucker.
>> I have to keep this from my wife or I am dead!!!!
>> I will post pics of the build of this 496" stroker as it gets assembled.
>> Later
>> Bill Harrison
>> 65 Coronet 2 dr post
>>
>
>
>
> Rich Kinsley '64 Dodge Polara 4dr 318poly w/goodies
>
>
> ----
> Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!
>
> 1962 to 1965 Mopar Clubhouse Discussion Guidelines:
> http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
>
>



-- 
Steve
'63 Hemi Polara

${bottom_text_ad}
----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.

This email was sent to: ${recipient}

u/?bUrDWg.${encoded_sub_id}.${EMC}