Re: Disc brake conversion/ torsion bar adjustment

[Don Hudson <mopar4me@xxxxxxxxxxx>]

Per Richard Ehrenberg's article concerning this swap, there is no 
difference in the height of the spindles between the 73-76 A Bodies  and 
the 62-72 B Bodies or 70-74 E Bodies.  The location of where the rotor 
mounts is the same as well.  Height measurements are taken at the bottom 
of the LCA.
Don  in VA

Butch Edison wrote:
>  My son probably had the correct analysis, that there is a difference between the 64 and 73 spindles which would affect the numbers.  
>
> If you know differently, please advise.
>
> Thanks/Butch/Ferndale, WA
>
>
> ----
> Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!
>
> 1962 to 1965 Mopar Clubhouse Discussion Guidelines:
> http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. 
>
>
>
>
>   


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.