RE: piston side clearance

[William Harrison <bbjt3@xxxxxxxxx>]

Dave
They are forged TRW pistons.
Any idea how much for this type?
Thanks
Bill

--- On Mon, 12/21/09, dwalters@xxxxxxxxxxxx <dwalters@xxxxxxxxxxxx> wrote:

> From: dwalters@xxxxxxxxxxxx <dwalters@xxxxxxxxxxxx>
> Subject: RE: piston side clearance
> To: 1962to1965mopars@xxxxxxxxxx
> Date: Monday, December 21, 2009, 5:07 PM
> 
> 
> William Harrison wrote:
> > 
> > Does any one out there have any info that applies to
> the piston side 
> > clearance to a stroker motor.
> > I know you need more for a quarter mile car versus a
> street car but I 
> > don't know how much more.
> > Thanks
> > Bill H
> > 65coronet 2 dr post.
> > 
> 
>  Generally, .003" - .055". It really depends on piston
> material and 
> application (N/A, nitrous, turbocharged etc. ).
> 
> Dave Walters
> Aurora, Co.
> 
> 
> ----
> Please address private mail -- mail of interest to only one
> person -- directly to that person.  I.e., send
> parts/car transactions and negotiations as well as other
> personal messages only to the intended recipient, not to the
> Clubhouse public address. This practice will protect your
> privacy, reduce the total volume of mail and fine tune the
> content signal to Mopar topic.  Thanks!
> 
> 1962 to 1965 Mopar Clubhouse Discussion Guidelines:
> http://www.1962to1965mopar.ornocar.org/mletiq.html and
> http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
> 
> 
>