Hi, I put the drum/hub combo on the concrete floor and hit the hub with the blunt end of an axe. One good whack and the hub dropped to the floor and I had them separate. The front drum also fits the back (once separated). Good luck. K. Steve Mick wrote: > > Today I finished up the paint detailing and installation of all front > suspension componets. I wanted to remove the drums from the hubs and > just > put the hubs on with wheels so I could move the car-64 Dodge. How the > heck > do you get the drums off the fron hubs??? I soaked everything with PB > blaster and tried dropping the drum on concrete hoping that the hub > would > fall in , but no such luck. Any tricks to get them > apart?.................MO > Kevin R. Merkley Thunder Bay, Ontario 64 Dodge 440 2dr HT (Cdn) 64 Dodge Polara 500 Convertible (Cdn) ---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! '62 to '65 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html.