RE: Torsion bar cushions??

[Steven Charette <stevec@xxxxxxxxxxxxxxxxxxxx>]

MO,
	'65 C-Bodies and '67-73 (and probably 74-75) Imperials had a torsion
bar crossmember anchor isolator (2071 514-5).  These were on the
transmission crossmember where the rear torsion bar anchor mounted to the
frame... that it??

SC

-----Original Message-----
From: MO ( Steve Mick) [mailto:micher@xxxxxxxxxxxxxxx] 
Sent: Tuesday, October 13, 2009 7:36 PM
To: 1962to1965mopars@xxxxxxxxxx
Subject: Torsion bar cushions??


On another forum there was a discussion about early Mopar torsion bars. 
Evidently they have a rubber cushion down inside the TB hex  of the lower
control arm . I guess between the front end of the TB and the back end of
the control arm bushing shaft.??? I never saw anything like that when I dis
assembled my 64 dodge--Is there supposed to be a cushion there
?..........................MO 


----
Please address private mail -- mail of interest to only one person --
directly to that person.  I.e., send parts/car transactions and negotiations
as well as other personal messages only to the intended recipient, not to
the Clubhouse public address. This practice will protect your privacy,
reduce the total volume of mail and fine tune the content signal to Mopar
topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.