RE: Axle

[Jeff Adams <ledman_70@xxxxxxxxxxx>]

Same here... put a 65 Coronet rear end in my 64 Polara. It was actually 
about an inch narrower so I could run a little wider tire/wheel.

mopar413@xxxxxxxxxxx wrote:
> 
> I have done that with my 64 I installed a 65 assembly.  Bolted right in. 
>  That is the best way.  
> ---- "Gary H." <spigot2039@xxxxxxxxxxx> wrote: 
> > 
> > Not the axle, but the whole '65 drum to drum assembly will fit in the 
> > '63.
> > 
> > Thanks,
> > Gary H. 
> > 
> > 
> > -----Original Message-----
> > >From: grportland 
> > 
> > >Will a 65 dodge work for a 63? Gene  
> > 
> > 
> > ----
> > Please address private mail -- mail of interest to only one person -- 
> > directly to that person.  I.e., send parts/car transactions and 
> > negotiations as well as other personal messages only to the intended 
> > recipient, not to the Clubhouse public address. This practice will 
> > protect your privacy, reduce the total volume of mail and fine tune the 
> > content signal to Mopar topic.  Thanks!
> > 
> > '62 to '65 Mopar Clubhouse Discussion Guidelines:
> > http://www.1962to1965mopar.ornocar.org/mletiq.html. 
> > 
> 



Jeff Adams
64 Polara


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.