I'll be watching this thread closely. I've been told that you can get some Chebby tape that was used on corvettes and inlay it into the areas where the trim has the turning marks, but I've not seen it. If there is a vendor out there who can take our old trim and restore it..... I'm in. /Butch/ Ferndale, WA -----Original Message----- From: Nick Tiberio [mailto:furyus63@xxxxxxxxxxx] Sent: Wednesday, July 29, 2009 2:50 PM To: 1962to1965mopars@xxxxxxxxxx Subject: Engine Turning Trim Does anyone know of a vendor that can supply the (engine turning jeweling) tape trim for the the side moldings on a 1963 Sport Fury. Also looking for a set of rocker panel moldings & clips for a 1963 Sport Fury. Nick Tiberio furyus63 ---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! '62 to '65 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html. ---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! '62 to '65 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html.