Re: Poly Strut Rod Bushings (installing)

[Ollie <satellite1965@xxxxxxxxxxx>]

I would say clean up the hole a bit with a grinder on my drill.
Ollie
----- Original Message ----- 
From: "J. O." <JJO1967@xxxxxxxxxxx>
To: "mopar" <1962to1965mopars@xxxxxxxxxx>
Sent: Wednesday, May 06, 2009 8:06 PM
Subject: Poly Strut Rod Bushings (installing)





I have poly bushings to go into my Valiant, and I have one of the poly strut 
rod bushings installed, but it was a nightmare to get in.

Would it still work if I cut it in two? Or is there a way to soften the poly 
material enough to squeeze it into its hole in the frame? Heat?

*Also, I read somewhere that the washers that go on either side of this 
bushing need to have the raised rim away from the bushing, rather than 
toward it, or premature wear would result. Any truth to this?


thanks,
Jim Ozolins
Indianapolis
'64 Signet 200

_________________________________________________________________
Hotmail® goes with you.
http://windowslive.com/Tutorial/Hotmail/Mobile?ocid=TXT_TAGLM_WL_HM_Tutorial_Mobile1_052009
--
[Non-text portions of this message have been removed]


----
Please address private mail -- mail of interest to only one person --  
directly to that person.  I.e., send parts/car transactions and negotiations 
as well as other personal messages only to the intended recipient, not to 
the Clubhouse public address. This practice will protect your privacy, 
reduce the total volume of mail and fine tune the content signal to Mopar 
topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 

This email was sent to: arc.6265@xxxxxxxxxxxxxx

u/?bUrDWg.bSONJP.YXJjLjYy



?p=TEXFOOTER