RE: Fuel system remake

[Steven Charette <stevec@xxxxxxxxxxxxxxxxxxxx>]

Rich,
	I'm trying to remember where I saw them, but someone is making the
fuel line clips (for along the inner side of the sill area) in 3/8" now... I
think it was R/T Specialties in PA.

SC 

-----Original Message-----
From: Rich Kinsley [mailto:rlkinsley@xxxxxxxxx] 
Sent: Thursday, July 23, 2009 11:19 PM
To: 1962to1965mopars@xxxxxxxxxx
Subject: Fuel system remake




Rich Kinsley '64 Dodge Polara 4dr 318poly w/goodies

Here's another fine mess I got myself into!

I have a 25' coil of 3/8" fuel line and the old one is laying on the floor
by it. I'm trying to match it up but that ain't easy! It's going OK and if
the tricky bends at the ends don't work out I'll just terminate them in
braided line. I'm not gonna do the old run the braided line all the way
trick. 

I have a few small kinks in a couple tight bends but I really don't think
they'll hurt the flow. Wish me luck.


----
Please address private mail -- mail of interest to only one person --
directly to that person.  I.e., send parts/car transactions and negotiations
as well as other personal messages only to the intended recipient, not to
the Clubhouse public address. This practice will protect your privacy,
reduce the total volume of mail and fine tune the content signal to Mopar
topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.