HEY Bob, your best bet is to find a automatic column as in the engine compartment will still have the shifter levers still on the steering column. -----Original Message----- From: incoming.verizon.net [mailto:moweepea@xxxxxxxxxxx] Sent: Thursday, July 23, 2009 1:15 PM To: 1962 1965 Subject: what camshaft? Hi all, I have a couple of questions. First I want to change my column shift to a floor shift. Does anyone know where I can find a sleeve that goes on the column to eliminate the sleeve that had the shifter? And I want to put in a camshaft in my 383, engine is stock but I want a little more HP., and not a lot of vacuum loss. Any ideas? Thanks, Bob ---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! '62 to '65 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html. ---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! '62 to '65 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html.