Do you have a Long Ram intake or something other than the T-10 that is unsual? If not I never supported the engine on a tranny pull. If your mounts are good the engine is not going anywhere. And you need not be concerned about your distributor cap!! (; I'm sure you know now is a good time to get that rear seal. I am not sure why you referred to jacking the engine on a tranny pull. Is their something your not telling us? Herb 1956 Plymouth Belvedere 361 1959 Coronet 326 Poly 1963 Fury 2D/HT 6.1 1963 Sport Fury Convertible 361 1970 Challenger RT 440 1999 Durango SLT 5.9 2006 300-C Heritage 5.7 2008 SRT-8 Magnum 6.1 St. Louis, MO. http://1962to1965mopar.ornocar.com/mmo42009.html -------Original Message------- From: Dennis C. Date: 6/12/2009 10:54:20 PM To: 1962to1965mopars@xxxxxxxxxx Subject: 4-Speed Trans Removal Question I need to pull the 4-speed transmission out of my 63 Sport Fury. I have a 383 and Borge Warner T-10 in the car. If I had help and more time I would prefer to remove the transmission and engine together but at this time it is not an option. My rear main seal is leaking but that can wait for now. I checked the manual and it referred to a fixture to support the rear of the engine? I was considering a length of 4"X4" wood with blocks on each end that would go up to the block castings on each side of the pan and jacking up the engine. Is there a better way? Any suggestions will be appreciated. Dennis C. 1996 Dodge Ram 3500 Van Conversion 1964 Plymouth Belvedere 318 Auto 1963 Plymouth Sport Fury 383 4-speed 1949 Dodge Pickup 289/C4 soon to be changed 1998 Honda Valkyrie Standard ---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! '62 to '65 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html. [Non-text portions of this message have been removed] ---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! '62 to '65 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html. This email was sent to: arc.6265@xxxxxxxxxxxxxx u/?bUrDWg.bSONJP.YXJjLjYy ?p=TEXFOOTER