I need to pull the 4-speed transmission out of my 63 Sport Fury. I have a 383 and Borge Warner T-10 in the car. If I had help and more time I would prefer to remove the transmission and engine together but at this time it is not an option. My rear main seal is leaking but that can wait for now. I checked the manual and it referred to a fixture to support the rear of the engine? I was considering a length of 4"X4" wood with blocks on each end that would go up to the block castings on each side of the pan and jacking up the engine. Is there a better way? Any suggestions will be appreciated. Dennis C. 1996 Dodge Ram 3500 Van Conversion 1964 Plymouth Belvedere 318 Auto 1963 Plymouth Sport Fury 383 4-speed 1949 Dodge Pickup 289/C4 soon to be changed 1998 Honda Valkyrie Standard ---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! '62 to '65 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html.