Re: Fender Spears

["Gary H." <spigot2039@xxxxxxxxxxx>]

Welcome back Jim. 

The places listed on the vendor's page have come from suggestions given here.
#  Librandi's Plating & Machine 
# Auto Medic  
# Tri-City Plating Co., Inc. 

Maybe one is near you. But I think they all do mail transactions. 

Thanks,
Gary H.



-----Original Message-----

>Jim Jablonski wrote:
>> Folks, apologies if this is an over-discussed post, but I have been away 
>> for a while.
>>
>> I need to get my side trim redone on my '64 Fury, and am looking for 
>> recommendations on a good vendor to use.  I looked into Ano-Brite a few 
>> years ago, but they were very expensive, and also appear to be call King 
>> of Trim now (?)
>>
>> Your thoughts are appreciated, as always...
>>
>> Jim
>>
>> Jim Jablonski
>> Royal Oak, Michigan
>> '64 Fury 


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.