Re: Rear-end gear ratios

["Gary H." <spigot2039@xxxxxxxxxxx>]

The "pre-digital" method posted on the tech page works with SureGrip and PegLeg versions.

Thanks,
Gary H. 

-----Original Message-----

>  I believe this method only works with a sure grip rear end- because of the 
>spider gears  in a non-posi.  You can use this method if both tires are on 
>the ground and you roll it straight ahead( or 
>back)......................MO.............sw  iowa
>----- Original Message ----- 
>From: "Herb"  
>
>
>
>I can tell you a EWAG (Educated Wild A$$ Guess) or probably just a WAG way
>of telling.  Lift the rear off the ground & rotate a tire one complete turn
>and count the rotations of the drive shaft and keep track at the end.  Three
>& 1/4 turns is 3.23.  Three & 1/2 turns is 3.55.  Four & 1/2 is 4.56 and so
>on and so on!  I hope this helps.  Unless it has been worked on or rusted
>off, it should have a tag on it somewhere with the ratio on it.
>
> 


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 

This email was sent to: arc.6265@xxxxxxxxxxxxxx

u/?bUrDWg.bSONJP.YXJjLjYy



?p=TEXFOOTER