If not a nut splitter,a compressor and whizzer to cut the nuts off. Not as dangerous as a torch if you're not familiar working with one. George --- On Thu, 2/12/09, MO ( Steve Mick) <micher@xxxxxxxxxxxxxxx> wrote: > From: MO ( Steve Mick) <micher@xxxxxxxxxxxxxxx> > Subject: Fw: Re: Help! How do I get rear wheel off > To: 1962to1965mopars@xxxxxxxxxx > Date: Thursday, February 12, 2009, 10:31 AM > Send 2 > -------Original Message------- > > From: Cheryl & Steve Mick > Date: 02/12/09 11:24:50 > To: 1962to1965mopars-subscribe@xxxxxxxxxx > Subject: Fw: Re: Help! How do I get rear wheel off > > I had the same idea as Herb. If you can drive your car , > many times this > Will work. For a nut splitter. Lisle tools makes these and > your local parts > House that sells Lisle should have > it.......................MO.............. > > .....SW Iowa > > -------Original Message------- > > From: Herb > Date: 2/12/2009 10:38:35 AM > To: 1962 to 1965 Mopars > Subject: Re: Help! How do I get rear wheel off > > > > Their is always the fire wrench. I get the stud hot and > blow the stud out > Of the center of the lug nut just before the bottom. Then > when it's still > Hot using a socket and long extension break it off or knock > it out with a > Punch, that way you wont hurt the wheel. Or pull the hub > off the axle with > The drum and burn the back of the studs off. That said, the > drums, I once > Had a drum & axle I could not get off and for a last > ditch effort I loosened > > > The axle nut a couple of turns with the wheels & tires > on and took it out in > > > The parking lot and did figure 8s heard both hubs pop > pulled in and pulled > Drums & hubs. Be Very Carful doing this and DO NOT > remove the axle nut just > Back it off 1/4 inch at the most and have an observer to > keep an eye on them > > > Use antiseize on the splines when reinstalling the hubs for > the next > Time!!. > > Herb > St. Louis, MO. > > -------Original Message------- > > From: laborboy@xxxxxxxxxxxxx > Date: 2/12/2009 8:46:32 AM > To: 1962to1965mopars@xxxxxxxxxx > Subject: Help! How do I get rear wheel off > > Not only do I have the infamous tapered rear axle spline in > my 1964 > Dodge Polara, I also have rear wheel studs that rotate when > you try to > Take the nuts off! I am dying for ideas here on how to > remove the wheel > And brake drum at the same time off these crazy tapered > axle. Any and > All suggestions will be very much appreciated! Zack > > > [Non-text portions of this message have been removed] > > > ---- > Please address private mail -- mail of interest to only one > person -- > Directly to that person. I.e., send parts/car transactions > and negotiations > As well as other personal messages only to the intended > recipient, not to > The Clubhouse public address. This practice will protect > your privacy, > Reduce the total volume of mail and fine tune the content > signal to Mopar > Topic. Thanks! > > '62 to '65 Mopar Clubhouse Discussion Guidelines: > http://www.1962to1965mopar.ornocar.org/mletiq.html. > > > . > > > > ---- > Please address private mail -- mail of interest to only one > person -- directly to that person. I.e., send parts/car > transactions and negotiations as well as other personal > messages only to the intended recipient, not to the > Clubhouse public address. This practice will protect your > privacy, reduce the total volume of mail and fine tune the > content signal to Mopar topic. Thanks! > > '62 to '65 Mopar Clubhouse Discussion Guidelines: > http://www.1962to1965mopar.ornocar.org/mletiq.html. ---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! '62 to '65 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html.