Their is always the fire wrench. I get the stud hot and blow the stud out of the center of the lug nut just before the bottom. Then when it's still hot using a socket and long extension break it off or knock it out with a punch, that way you wont hurt the wheel. Or pull the hub off the axle with the drum and burn the back of the studs off. That said, the drums, I once had a drum & axle I could not get off and for a last ditch effort I loosened the axle nut a couple of turns with the wheels & tires on and took it out in the parking lot and did figure 8s heard both hubs pop pulled in and pulled drums & hubs. Be Very Carful doing this and DO NOT remove the axle nut just back it off 1/4 inch at the most and have an observer to keep an eye on them Use antiseize on the splines when reinstalling the hubs for the next time!!. Herb St. Louis, MO. -------Original Message------- From: laborboy@xxxxxxxxxxxxx Date: 2/12/2009 8:46:32 AM To: 1962to1965mopars@xxxxxxxxxx Subject: Help! How do I get rear wheel off Not only do I have the infamous tapered rear axle spline in my 1964 Dodge Polara, I also have rear wheel studs that rotate when you try to take the nuts off! I am dying for ideas here on how to remove the wheel and brake drum at the same time off these crazy tapered axle. Any and all suggestions will be very much appreciated! Zack [Non-text portions of this message have been removed] ---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! '62 to '65 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html. This email was sent to: arc.6265@xxxxxxxxxxxxxx u/?bUrDWg.bSONJP.YXJjLjYy ?p=TEXFOOTER