I've run them both on my 62 and 64 Dodge, and didn't have to do any cutting. Just be careful on the carb studs , that they do not come up to high. They will impact your hood and leave a dent!! Been there and done that....
Butch----- Original Message ----- From: "Wakeman Massie" <wakey@xxxxxxxxxxx>
To: <1962to1965mopars@xxxxxxxxxx> Sent: Thursday, December 18, 2008 5:37 PM Subject: Hood Clearance
Is anyone running a Max Wedge crossram w/ stock or reproduction air cleaners on an uncut '62 or '63 hood?I know Chrysler cut the inner support structure out on these hoods for Max Wedge applications but I was wondering if the stock crossram setup will fit without doing so. A similar topic was brought up recently so I know it is close.Thanks, Wakeman [Non-text portions of this message have been removed] ----Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks!'62 to '65 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html.
---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! '62 to '65 Mopar Clubhouse Discussion Guidelines:http://www.1962to1965mopar.ornocar.org/mletiq.html.