Do you suppose ???

[Rich Kinsley <rlkinsley@xxxxxxxxx>]

Rich Kinsley '64 Dodge Polara 4dr 318poly w/goodies

After installing the new plywood spacers on my carbs I had a problem 
with the old throttle bracket as it wasn't positioned the same due to 
the increased height. I wasn't getting full throttle and it was pulling 
sideways a bit on the cable. So I got the Lokar Edelbrock throttle 
bracket. It is perfect! Everything is lined up right on! But I still can 
only get about 3/4 throttle at best. My foot feed is right down against 
the carpet which is at least an inch thick. 

I wonder if my lazy topend could've been that I wasn't running full 
throttle? Don D mentioned this before with Eddy's but when I would open 
them by hand it was fine. Do you suppose this has been an issue I didn't 
recognize before? Geez, how dumb.


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.