Another radiator hose question

[Lee Sumpter <leesumpter@xxxxxxxxx>]

I found a molded hose to fit the lower side of my 64 Plymouth 361. However
after I installed it, I realized that it did not have the spring inside. The
FSM says that the spring is necessary to prevent the hose from sucking shut
at high speeds/rpms. Anyone on the list have any experience with this? Am I
going to have problems with this, or should I find another hose with the
spring?
Thanks for your opinions.........

-- 
Lee Sumpter

[Non-text portions of this message have been removed]


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.