RE: valve guide seal-spring?

["Gary H." <62to65mopar@xxxxxxxxxxx>]

Ah, I see. Thanks.

Gary H. 


65 wrote:
> 
> No. You can use this tool with the heads on or off the engine. Off the
> engine,with the heads on the bench,jam the rag or rope into the chambers 
> with
> the heads sitting,chambers-down, on the bench. (rag between valves and
> bench)Then use it the same as you would with the heads on the engine 
> with
> compressed air.
> -- 
> Darwin/Victoria/BC Canada
> '65 Cdn.Val.Custom 100'vert
> 170/A833...eternal project
> '67 Dart GT'vert
> 273/904...now with "Collector" status
> 
> 
> Quoting "Gary H." <62to65mopar@xxxxxxxxxxx>:
> 
> > 
> > You mean the non-C clamp tool with the heads ON the engine?  :)
> > 
> > Thanks,
> > Gary H.
> > 
> > 65 wrote:
> > > 
> > > You can use this tool with the heads off the engine....Just jam a rag or 
> > > 
> > > piece
> > > of rope in the combustion chambers(to hold the valves up) and proceed as 
> > > 
> > > usual.
> > > Has worked for me for years. It is a neat tool!  


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.