I have a 65 Belvedere with a trunk light in it. The light is inop and I replaced the bulb. I am not an electrical person so I will try and describe the set-up. There is a plunger device on the left side of the trunk. It has 1 wire attached to it running to the bulb mechanism. The bulb has 2 wires coming out of it. One to the plunger and the other to nothing. Should this be a ground wire? Also, I have a wire coming from behind the backseat that is not connected to anything. Shouldn't the plunger be receiving juice from somewhere? Todd - 1965 Plymouth Belvedere II ---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! '62 to '65 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html.