RE: 65 Kickdown Adjustment

["Gary H." <62to65mopar@xxxxxxxxxxx>]

I seem to recall the procedure is to adjust the kickdown by having 
someone press the gas pedal fully to the floor; then synchronize the 
kickdown linkage so that the lever on the trans is fully engaged.

Gary H.  


Bill Maurits wrote:
> I currently have the kickdown linkage adjusted so that it's mating
> face to the carb stud is ~3/8" farther forward than the carb stud
> itself, so there's always SOME pressure on the linkage. I don't
> remember how much father forward I can go and not screw something up.
> ...


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.