I don't think they are. I know that much of the clutch linkage (fork, fork pivot for example) are different. ----- Original Message ----- From: Brian Schlump<mailto:jsbs@xxxxxxxxxxxxx> To: 1962to1965mopars@xxxxxxxxxx<mailto:1962to1965mopars@xxxxxxxxxx> Sent: Wednesday, August 01, 2007 6:58 PM Subject: Z bar pivot Does anyone know whether the z bar pivot that bolts to the bellhousing on a '66 big block (10.5" housing)is the same as the one used on a '64 big block (10.5" housing)? Brian '64 Belvedere Davenport, Iowa "The difference between ordinary and extraordinary is that little extra." ---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! '62 to '65 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html<http://www.1962to1965mopar.ornocar.org/mletiq.html>. [Non-text portions of this message have been removed] ---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! '62 to '65 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html.