RE: Heater Stuff Again

[ledman_70@xxxxxxxxxxx]

Are the 65 and 64 B heater control valves similar Bill? My 64 just 
pushes into the core with an O ring on the end and 2 screws to hold it 
to the box.

Bill Maurits wrote:
> 
> I never did get my heater totally squared away this winter. Since I
> can't even get close to 3000 rpm without my heater control valve
> pissing on my foot, I need to find a gasket for it.
> 
> SO...does anyone know of a source for FLAY donut gaskets? I'm looking
> for something that's rubber, ~1/16" thick, and obviously bit enough to
> go around the nub where the heater control valve goes into the heater
> core. Any suggestions? Any places that sell flat sheets of similar
> material that I could make it myself?
> 
> Thanks
> 
> Bill M
> 65 Coronet 500 'vert



Jeff Adams
64 Polara


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.