On 53 01/09/07, Bill Maurits wrote: > The VR I got is supposed to be an electronic replacement of the > original mechanical unit for my car. Looking straight at it from the > top, the new elec and old mech versions look identical, but from the > side, the new elec one is MUCH shorter. the two wires that go to it are "IGN" and "FLD" wires,.. blue and green (I think),, if you connect them it'll remove the VR from the circuit. sounds like an unlikely cuprit, but its good to rule it out.... the single groove pulleys were also used on later higher amp alts that weren't AC units.., too... a real volt meter (or the volt meter part of a DMM) would be great to tell you the charge... good luck. ---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! '62 to '65 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html. This email was sent to: arc.6265@xxxxxxxxxxxxxx http:///u/?.. Or send an email to: 1962to1965mopars-unsubscribe@ http:///?p=