Dana 44 question
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Dana 44 question



I am rebuilding a Dana 44 rear end and I just pulled the axles out and it
looks like the bearing race might have spun inside the axle tube housing.  I
was wondering if anyone knows what the inside diameter of the tube is
supposed to be or has any experience rebuilding these types of axles.  I
also and not quite sure how the bearings come off, it seems like you would
just slide them off the axle shaft, but I'm not sure what type of puller I
need or other tool.  The Dana 60's I have rebuilt in the past I have bought
complete new axles for and the bearings already came on the axle, this will
be the first time I have actually changed the bearings.  Any suggestions or
help would be greatly appreciated.

Thanks,
Garrett Safford

1962 Dodge Dart 440
1971 International Harvester Travelall


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 

This email was sent to: arc.6265@xxxxxxxxxxxxxx

http:///u/?.. 
Or send an email to: 1962to1965mopars-unsubscribe@


http:///?p=




Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.