Re: Valve Cover Resto
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Valve Cover Resto




I was thinking about trying something like that, but even w/ 7MM
wires, the plug wire shaft is TIGHT in the hole in the loom. Were the
wires much smaller in 65?

Bill M
65 Coronet 500 'vert

On 11/30/06, ledman_70@xxxxxxxxxxx <ledman_70@xxxxxxxxxxx> wrote:

When I put new wires on my 426 I snipped a quarter inch section off an
old plug boot, slit one side, and installed them between the wire and
loom...works pretty good since I couldn't find any grommets.
Jeff
Bill Maurits wrote:
>
> I'm thinking about pulling my valve covers and possibly intake this
> winter for a clean up & repaint. The wire looms that are on the VC's
> are metal but appear to have had SOMETHING on the area where the plug
> wires snap it. Any ideas whet this was and or what I could use now?
> Maybe some plasti-dip? I just changed the wires and you can see where
> the now bare metal looms were cutting into the wires.
>
> Thanks
>
> Bill M
> 65 Coronet 500 'vert



Jeff Adams
64 Polara


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.
This email was sent to: arc.6265@xxxxxxxxxxxxxx

bSONJP. Or send an email to: 1962to1965mopars-unsubscribe@







Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.