Re: Wanted:64 4 spd. tail housing

[Doug Ahern <D170A833@xxxxxxxxxxxxxxxxxxx>]

On 25 11/19/06, Dave Walters wrote:
> I know it's a long shot,but I wouldn't mind gettting ahold of a 64 4 spd 
> tailhousing.I have a 66-69 part,but would rather use the correct 
> part.The early housing has a small (compared to the later one) speedo 
> gear hole.Thanks. 


I have one for a C-body,  its identical except for the spacing of the
tranny mount.  I was using it with a regalur B-body mount that I 
modified to extend the mounting holes... 

you will also need to swap the mainshaft  as its different it
order to accept the flange.  I have all of that.

see
http://www.autohobbydigest.com/image.php?A833-BCBNT-tshafts.jpg

I'm up for a trade for your later parts, or I could just sell'em
to you.


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 

This email was sent to: arc.6265@xxxxxxxxxxxxxx

bSONJP. 
Or send an email to: 1962to1965mopars-unsubscribe@