need help

[Don Dulmage <big-d@xxxxxxxxxxxx>]

Does anyone out there have a stock 360 piston that they could weigh on a digital scale (without rings or pin, etc?)  Postage digital sacle is suffficient for what i want to know. Must be a stock factory 360 piston or silvolite cast or similar . (Not forged or hypereutechtic)   i am working on the poly project and need the weight so i can make the new pistons the same. I used to have lots of them but they went with my shop equipment I guess.  Our goal is to produce a set up that wont require rebalance for street use if possible. just use the 360 flywheel and balancer. Then anyone can do it at home for low $$ with no problems. We may make a few sets if it goes well. 
Don 
Author of
Return to Deutschland (True Adventure)
Old Reliable (Mopar)
http://stores.ebay.ca/Don-Dulmage-Enterprises
http://seniordragster.bravehost.com/index.html
[Non-text portions of this message have been removed]


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 

This email was sent to: arc.6265@xxxxxxxxxxxxxx

bSONJP. 
Or send an email to: 1962to1965mopars-unsubscribe@