I have one from a '62 engine. I could get it this weekend for you Ray ----- Original Message ----- From: "Richard Kinsley" <r.kinsley@xxxxxxxxxxxxxxxx> To: <1962to1965mopars@> Sent: Monday, October 23, 2006 8:42 PM Subject: RE: anyone have a poly flex plate ? > > > streetwedg@xxxxxxx wrote: > > > > > > Does anyone have a flex plate for a 318 poly that they would sell? > > I just pulled my trans and all four corners of flex plate were broken > > off. > > i need one to put car back in service. > > > > streetwedg > ------------------------------------------------------------------- > > I have my original that I don't need. You can have it, I just gotta find > it. It's not that heavy and should ship easily via USPS. I'll look for > it. E-mail me back if interested. > > > Rich Kinsley '64 Polara 4 dr 318poly w/goodies > > > ---- > Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! > > '62 to '65 Mopar Clubhouse Discussion Guidelines: > http://www.1962to1965mopar.ornocar.org/mletiq.html. > > ---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! '62 to '65 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html. This email was sent to: arc.6265@xxxxxxxxxxxxxx bSONJP. Or send an email to: 1962to1965mopars-unsubscribe@