Re: How best to jack up motor

[tom hecht <baddd65@xxxxxxxxx>]

[AD removed for archives]
-------------------------------------------------------------------
Get a Free Sirius Satellite Package, don't pass on this!
caadwPhbOyW3Na/ProductTestPanel
-------------------------------------------------------------------

i always use a good wide board, no problems.
but do you have to raise the motor or are you doing
it per instructions?
the tti's slid right into mine on both sides, as long
as the car is high enough to get a good angle.

tom
65 satellite
(440/727)



--- Brian Safford <bsafford@xxxxxxxxxxxxx> wrote:
> I need to raise my motor 1/4" so that the steering
> linkage clears the TTI
> headers.
> 
> Will doing so cause any issues with the
> transmission/drive shaft alignment?
> 
> Also, can I put a stout board between the floor jack
> and the oil pan and
> lift the motor there?
> 
> Regards,
> Brian Safford
> '62 Dart 440
> 
> Your free subscription is supported by today's
> sponsor:
>
-------------------------------------------------------------------
> Need a new washer and dryer set? You could get one
> free!
>
caadtaGbOgXg2f/ProductTestPanel
>
-------------------------------------------------------------------
> 
> ----
> Please address private mail -- mail of interest to
> only one person -- directly to that person.  I.e.,
> send parts/car transactions and negotiations as well
> as other personal messages only to the intended
> recipient, not to the Clubhouse public address. This
> practice will protect your privacy, reduce the total
> volume of mail and fine tune the content signal to
> Mopar topic.  Thanks!
> 
> '62 to '65 Mopar Clubhouse Discussion Guidelines:
> http://www.1962to1965mopar.ornocar.org/mletiq.html. 
>
> 
> 
> 
> 


		
__________________________________ 
Discover Yahoo! 
Stay in touch with email, IM, photo sharing and more. Check it out! 
http://discover.yahoo.com/stayintouch.html

[AD removed for archives]
-------------------------------------------------------------------
Need a new washer and dryer set? You could get one free!
caadtaGbOyW3Nf/ProductTestPanel
-------------------------------------------------------------------

----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 



bOyW3N.