I have some questions that arise from this thread. Back in the day ('60's) most all speakers were 8 ohm. Modern speakers seem to be mostly 2 ohm. So my limited understanding of electronics makes me think that modern devices such as the shown bluetooth microprocessor would have to work much harder, limiting their potential volume output when paired with older 8 ohm speakers.The other question is relevant for 6 volt (+) ground systems. In his hand drawn schematic he shows 6 volts (-) being connected to what would normally be the 12 volt (+) input on the bluetooth device. Or am I misunderstanding this particular point?Paul L.On Tuesday, September 27, 2022 at 1:28:12 PM UTC-5 Steve H. wrote:A low tech solution I use is to just pair up a battery-powered Bluetooth-enabled speaker with a cell phone, then stream music from Spotify, Amazon Prime, Pandora etc. There are pretty good quality speakers available for not too much that easily fit on the dash, on or under a seat, etc. but can be readily stored away for shows.
Some years back, I installed a retro type radio, but never could figure out how to replace the speakers in the dash.
SteveGet Outlook for iOS
From: 1962to19...@xxxxxxxxxxxxxxxx <1962to19...@xxxxxxxxxxxxxxxx> on behalf of 62-65-mail-list-club-Gary-H <62-65-mail...@xxxxxxxxxxx>
Sent: Tuesday, September 27, 2022 2:01:46 PM
To: 1962to19...@xxxxxxxxxxxxxxxx <1962to19...@xxxxxxxxxxxxxxxx>
Subject: Re: Sound upgrade....BluetoothGood questions. The applications I've seen mostly go through the existing radio, for example this install in a 1967 Fury:
https://www.youtube.com/watch?v=6RnsO_R39kY
There are external Bluetooth enabled speakers that also have input jacks to plug in a wire connection from a headphone jack in a phone (if the phone has one!). My limited experience is wire connection works better.
https://www.amazon.com/dp/B08HHZFVYC/ref=sspa_dk_detail_1 is an example.
Then you use the controls on the phone / output device to select the treble, bass, and volume.
That's about it for my pay grade on this topic. :)
Thanks,'
Gary H.
> -------Original Message-------
>
> Hi folks. I watched a youtube video where a gentleman attached a
> Bluetooth microprocessor to his existing speakers, effectively
> bypassing the radio entirely.. I purchased the parts needed from
> Amazon and used the setup from the youtube video for my experiment.
> The first third of the video is all that’s relevant.
>
> https://www.youtube.com/watch?v=GpZ9vRPuBUY&t=114s
>
> I would like to do the same so I can Bluetooth music from my phone and
> listen to 60s music. I have room for a front and rear speaker in my
> 1964 Plymouth Sport Fury. I would like to know what you recommend for
> a Bluetooth microprocessor and speaker outputs to get better sound. If
> possible, I’d like to control the treble, bass, and volume. Is 100
> watt a possibility for the speakers? Of course, it has to run off of
> 12 volt. Appreciate any advice and product info you can offer.
>
> Here’s a 6”x9” speaker that would fit my rear deck
> https://www.retromanufacturing.com/collections/dash-speakers/products/6x9-inch-ultra-thin-dash-speaker
>
>
> I think I’d have to make a plate to mount a 7” speaker to the
> front dash, which is okay.
>
> I'd appreciate any advice or comments.
>
> Thanks/ Butch
--
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.
---
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopa...@xxxxxxxxxxxxxxxx.
To view this discussion on the web visit https://groups.google.com/d/msgid/1962to1965mopars/20220927180146.52596.qmail%40server309.com.
Back to the Home of the Forward Look Network