RE: Junkyard '63 8.75 Rear

[tduross1@xxxxxxxxxxx]

===========================================================
Let University of Phoenix make 2004 your year. Evening, 
weekend or FlexNet® classes ? over 130 locations. Look 
into our programs and get the degree that gets you going!
caaccMPb7yoMza/ UOP
===========================================================



Large 1-1/8" hexnut and cotter pin outside the drum.
'64 was the last year for tapered axles I believe.
What's wrong with a tapered axle rear end?

Tom Duross


-----Original Message-----
From: Dodger7998@xxxxxxx [mailto:Dodger7998@xxxxxxx]
Sent: Tuesday, May 11, 2004 7:37 PM
To: 1962to1965mopars@xxxxxxxxxx
Subject: Re: Junkyard '63 8.75 Rear


It is very easy to tell if it is a tapered axle car, the tapered axles have
a
large hex nut in the center of each brake hub, on the outside of the car.
     The crossmember would be the same for a small block or big block
engine,
you would have to measure the bolt holes in the transmission to tell if it
had a big block in it or not

       dodger

===========================================================
Cancel your low-carb diet. Lose weight. Choose your own 
foods. Learn more about our program at:
caaccM7b7yoMzf/ Dr. Smith
===========================================================

----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 



b7yoMz.