Floor Pan Advice

[Andrei Pasternak <swirldesign@xxxxxxxxxxx>]

Hi All,

After finally pulling the rotted carpet and removing excess rust, the 
front floor pans
on my 64 Fury are a little worse than I thought; I found a few little 
holes that were
hiding under that rust. So i need some advice, should I just have a 
body shop spot
weld the areas that are bad? (I'm not a big fan of fiberglass) or 
should I replace the
floor pans altogether? In either case the thin cover of the wire 
routing channel that
runs along each door sill is also not in great shape does anybody know 
if that cover
can still be purchased anywhere? If not, it seems like it's probably 
easy to fabricate.
Any experiences, advice, thoughts would be greatly appreciated. Thank 
you,

Andrei
64 Fury 361 
 

----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 


b7yoMz.