Just to throw it out there, Dennis, what would happen if you just left
the converter out? I don't know either, but someone around here
probably does.
If that wouldn't damage the tranny, and I don't see how it could, it
would certainly simplify the project.
BC
On 1/18/2014 2:37 PM, Dennis C. wrote:
> I have a Torqueflite that has been completely drained, both the pan
> and the torque converter. The torque converter was drained by
> removing the plug on the converter.
>
> I need to attach it to an engine that I want to run for cam break-in.
> The engine is not in a car, it is on a solid stand that will support
> it and the transmission.
>
> Question
> Can I just fill the converter through the drain and not remove it from
> the transmission and if so do I completely fill it or just put in a
> quart like when the converter has been removed?
>
> How much fluid should I put in the transmission?
>
> The transmission has a spline tail shaft so I was thinking about just
> using one of the plastic caps to keep it from leaking.
>
> My concern is that when I start the engine I would like to do a full
> 20 minutes or more for cam break-in at 2,000 to 2,500 rpm. I am open
> to any and all suggestions how to get this done, I need the
> transmission connected to be able to start the engine.
>
> Thanks
> Dennis C.
> --
> --
> --
> Please address private email -- email of interest to only one person
> -- directly to that person. That is, email your parts/car transactions
> and negotiations, as well as other personal messages, only to the
> intended recipient. Do not just press "reply" and send your email to
> everyone using the general '62-'65 Clubhouse public email address.
> This practice will protect your privacy, reduce the total volume of
> mail and fine-tune the content signal to Mopar topic. Thanks!
>
> 1962 to 1965 Mopar Clubhouse Discussion Guidelines:
> http://www.1962to1965mopar.ornocar.org/mletiq.html and
> http://www.1962to1965mopar.ornocar.com/general_ .disclaimer.html
> --
> You received this message because you are subscribed to the Google
> Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
> http://groups.google.com/group/1962to1965mopars?hl=en .
>
> ---
> You received this message because you are subscribed to the Google
> Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
> To unsubscribe from this group and stop receiving emails from it, send
> an email to 1962to1965mopa...@googlegroups.com .
> For more options, visit https://groups.google.com/groups/opt_out .