Re: dry small block cylinders

["Dennis C." <dennis.2914@xxxxxxxxx>]

Neal,

 

Good to see you back on the board.

 

It was for pre-lubing the engine.  As I recall it involves hanging something like an IV bag above the engine with oil.  A tube from the bag to the engine oil pressure port  if I recall correctly and let the oil slowly drain into the engine lubricating all bearings.

 

I suspect someone will give more detail

 

Take Care

Dennis C.

On Monday, September 30, 2013 5:23:30 PM UTC-6, neal wrote:

I remember don D but not the IV method, care to refresh?

   Neal

On Mon, Sep 30, 2013 at 11:18 AM, Gary H. <62to6...@xxxxxxxxxxx> wrote:

I forgot to mention the Don D. "IV bag" method of pre-oiling a dry engine.

Thanks,
Gary H.

>  -------Original Message-------

>
>
>  I don't think the engine will care about brand as long as some oil is there, but a lot of folks seem to like using about a teaspoon of  Marvel Mystery Oil in each piston hole. Pull all the plugs and put the oil  in each cylinder then hand-turn the engine several full rotations.
>
>  Thanks,
>  Gary H.

--
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

---
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopa...@googlegroups.com.
For more options, visit https://groups.google.com/groups/opt_out.

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.
 
--- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxxx
For more options, visit https://groups.google.com/groups/opt_out.