Re: dry small block cylinders

["Gary H." <62to65mopar@xxxxxxxxxxx>]

I don't think the engine will care about brand as long as some oil is there, but a lot of folks seem to like using about a teaspoon of  Marvel Mystery Oil in each piston hole. Pull all the plugs and put the oil  in each cylinder then hand-turn the engine several full rotations. 

Thanks,
Gary H. 

>  -------Original Message-------
 
>  
>  After much deliberation I am going to sell the 64 barracuda, so I can
>  concentrate on my 2 B-bodies. It has sat for a few years so I am going to
>  pre-prime the oil pump and I also want to squirt something lubricating into
>  the cylinders before fire up. What do u guys think I should use?? ...

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

--- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxxx
For more options, visit https://groups.google.com/groups/opt_out.