Re: New Welder Recommendations ??

[Doug J <63sprtfury@xxxxxxxxx>]

I have a good friend that is a welder by profession, and bought a 110 unit for use in his shop at home,, figuring too that it would do any light job he would run into.  He quickly found out differently and now has a 220 unit.  Guess it's the old "better to have it and not need it,, than to need it and not have it"

Doug,
'63 Sport Fury 'vert


I am considering a MIG welder.

A friend suggested that a 120 volt unit is all that I would need, it
would be able to weld up to 3/16" to 1/4" mild steel and that is all I
would ever need.

I have looked at some at a welding supply house and Eastwood has this
one on special:

http://www.eastwood.com/review/product/list/id/5075/?p=5

Any comments on MIG welders would be appreciated.

Thanks
Dennis C

-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.